![]() The Stereo Mix device will be shown, enable it by clicking the right mouse button on its icon and checking the corresponding option.Make the right click within the Recording empty area and check the Show Disabled Devices option.Open the Recording tab in the appeared window.If you are using Windows XP or 2003, click the Start menu button and open the Control Panel.If you are using Windows Vista or 7, click the Windows recording control button below this drop-down list and proceed to Point 5.Note: if the drop-down list doesn't contain the Stereo Mix option (the Windows Vista case mainly) and you are completely sure your sound card supports the Sound Mix feature then: ![]() Note: some settings can be disabled depending on the operating system installed on your computer and your sound card. Select the Start recording to the current file option to record your music to the created file. Recording Path - specify the file where the recorded audio will be saved to.Recording Mode - choose the way you want to record new audio: you can either overwrite the original sound or mix it with the recorded audio.Gain - set the loudness of the device input.Balance - set the difference of the sound volume between the right and the left channel.Note: you can enable or disable the needed device and adjust its properties directly from the program interface using the Windows recording control button to open the window with the list of Windows recording devices.Īfter selecting the Stereo Mix option you can adjust the following recording settings: Select the Stereo Mix option in the Input drop-down list. The Options window will appear with the opened Recording tab. If you press the Advanced button of the Recording Options group you will be able to configure the same parameters and some additional recording settings. Here you can quickly adjust general recording settings: select and test an input device, set its balance and gain. Open the Record tab to be able to adjust recording settings. Use the OK button to save the selected parameters and close the New File window. ![]() The following parameters are available: Sample Rate, Sample Size, Number of Channels and New File Name. The New File window will be opened allowing you to define file properties that will contain the recorded audio data. button on the Home tab of the Ribbon Command Bar. After the download is finished, run the AVSInstallPack.exe file and follow the installation wizard instructions.Ĭlick the New. AVS Audio Editor will help you perform this task.Ĭlick here to get it. If you need to record music or any other sounds produced by the computer you can use the Stereo Mix feature of your computer sound card.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |